DiniTech NRGkick Gen2
EV chargers Fully supported Confirmed live ✓
This device runs on one of our own installations. We didn't just build it from the data sheet — we've measured and controlled it ourselves.
What Franzl can do with this device
| Measure live power | ✓ |
| Meter energy (kWh) | ✓ |
| Read state of charge (SoC) | — |
| Control power | ✓ |
| Control operating mode | ✓ |
| Switch phases (1↔3-phase) | ✓ |
How it connects
Franzl reads this device through the Home Assistant integration nrgkick. If your device is already set up there, Franzl finds it automatically.
Setup
Activate the local JSON API in the NRGkick app (Settings → Advanced → Local API). Note the IP address and, if applicable, username/password.
Prerequisites
- SmartModule firmware ≥ 4.0.0.0
- Local JSON API activated in the NRGkick app
- NRGkick on the same network as the Franzl Gateway
What you enter
- NRGkick IP address: Required
Example:
192.168.1.42 - Username (optional): optional Example: leave empty if no auth
- Password (optional): optional
Device fits? Then nothing stands between you and getting started.
Install Franzl