M-TEC WPL / WPLK / WPLT / WPD / WPS (KEBA KeEnergy)
Heat pumps Hot water Basic support
What Franzl can do with this device
| Measure live power | ✓ |
| Meter energy (kWh) | ✓ |
| Read state of charge (SoC) | — |
| Read temperature | ✓ |
| Control power | — |
| Control operating mode | ✓ |
| Set target temperature | ✓ |
How it connects
Franzl uses the Home Assistant custom integration superbox-dev/keba_keenergy (installable via HACS). If your device is set up there, Franzl finds it automatically.
Setup
Connected via the HACS custom integration keba_keenergy, which accesses the web interface of the KEBA KeEnergy controller (AP440 display) locally, no cloud needed.
Requirements
- Firmware version 2.3.2-6 or later (heat pumps from May 2021 onward)
- PV surplus operation must be unlocked on the AP440 display with a technician level-3 login. Your installer usually takes care of this
Device fits? Then nothing stands between you and getting started.
Install Franzl