Hardy Barth (echarge) cPH2 / cPµ2 (Salia)
EV chargers Basic support Control prepared
This device's interface is documented by the manufacturer and captured in the profile. The driver for it is not built yet. Franzl reads the device and includes it in the optimisation, but cannot control it yet.
What Franzl can do with this device
| Measure live power | ✓ |
| Meter energy (kWh) | ✓ |
| Read state of charge (SoC) | — |
| Control power | — |
| Control operating mode | — |
| Switch phases (1↔3-phase) | — |
How it connects
Franzl connects to the device directly and locally: via its IP address in your home network, no cloud detour.
Setup
Franzl connects directly to your wallbox's Salia controller via its local IP address; a Home Assistant integration is not needed for this.
Requirements
- Disable the internal solar logic on the controller so it doesn't regulate in parallel with Franzl
- If your access is protected with installer credentials (Basic Auth), Franzl will ask for these when needed
What you enter
- Wallbox IP address: required
Device fits? Then nothing stands between you and getting started.
Install Franzl